Contact Email List
FAQ  •  Register  •  Login

tailshaft stud?

Moderators: toaddog, TWISTY, V8Patrol, Moderators

<<

was a 75

Posts: 118

Joined: Fri Nov 20, 2009 7:24 pm

Location: mt crosby

Post Sun May 01, 2016 7:09 pm

tailshaft stud?

Does anyone know if the studs (transfer case end) where the tailshaft bolts up on a 75 cruiser ute can be flogged out so i can replace with longer bolts? cheers
<<

bazzle

User avatar

Posts: 2499

Joined: Sun Nov 24, 2002 8:57 pm

Location: Melbourne

Post Wed May 11, 2016 11:59 am

Re: tailshaft stud?

If they have a flat back like a wheel stud then probably.
Remove flange 1st though and sit on vice jaws etc so you don't distort flange.
<<

was a 75

Posts: 118

Joined: Fri Nov 20, 2009 7:24 pm

Location: mt crosby

Post Wed Dec 14, 2016 8:59 am

Re: tailshaft stud?

Just did this to fit a transfer handbrake. Buy a ball joint puller and wind them out. Easy as. Marks adaptors sell longer studs.

Return to General Tech

Who is online

Users browsing this forum: No registered users and 2 guests

cron
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group.
Designed by ST Software.
eBay Sniper
Time : 0.073s | 13 Queries | GZIP : Off | Load : 0.12